Home > Blogs > VMware VROOM! Blog


Storage DRS Performance Improvements in vSphere 6.7

Virtual machine (VM) provisioning operations such as create, clone, and relocate involve the placement of storage resources. Storage DRS (sometimes seen as “SDRS”) is the resource management component in vSphere responsible for optimal storage placement and load balancing recommendations in the datastore cluster.

A key contributor to VM provisioning times in Storage DRS-enabled environments is the time it takes (latency) to receive placement recommendations for the VM disks (VMDKs). This latency particularly comes into play when multiple VM provisioning requests are issued concurrently.

Several changes were made in vSphere 6.7 to improve the time to generate placement recommendations for provisioning operations. Specifically, the level of parallelism was improved for the case where there are no storage reservations for VMDKs. This resulted in significant improvements in recommendation times when there are concurrent provisioning requests.

vRealize automation suite users who use blueprints to deploy large numbers of VMs quickly will notice the improvement in provisioning times for the case when no reservations are used.

Several performance optimizations were further made inside key steps of processing the Storage DRS recommendations. This improved the time to generate recommendations, even for standalone provisioning requests with or without reservations.

Test Setup and Results

We ran several performance tests to measure the improvement in recommendation times between vSphere 6.5 and vSphere 6.7. We ran these tests in our internal lab setup consisting of hundreds of VMs and few thousands of VMDKs. The VM operations are

  1. CreateVM – A single VM per thread is created.
  2. CloneVM – A single clone per thread is created.
  3. ReconfigureVM – A single VM per thread is reconfigured to add an additional VMDK.
  4. RelocateVM – A single VM per thread is relocated to a different datastore.
  5. DatastoreEnterMaintenance – Put a single datastore into maintenance mode. This is a non-concurrent operation.

Shown below are the relative improvements in recommendation times for VM operations at varying concurrencies. The y-axis has a numerical limit of 10, to allow better visualization of the relative values of the average recommendation time. 

The concurrent VM operations show an improvement of between 20x and 30x in vSphere 6.7 compared to vSphere 6.5 

Below we see the relative average time taken among all runs for serial operations.

The Datastore Enter Maintenance operation shows an improvement of nearly 14x in vSphere 6.7 compared to vSphere 6.5

With much faster storage DRS recommendation times, we expect customers to be able to provision multiple VMs much faster to service their in-house demands. Specifically, we expect VMware vRealize Automation suite users to hugely benefit from these improvements.

6 thoughts on “Storage DRS Performance Improvements in vSphere 6.7

  1. Pingback: Storage DRS Performance Improvements in vSphere 6.7 – VMPRO.AT – all about virtualization

  2. Michael

    For me, it looks as if the comparison bar is missing from the diagrams..

    Reply
    1. Venu

      The values shown in the charts are relative values(6.7/6.5) as a percentage, the reference 6.5 value of the avg. recommendation time for each operation is normalized to 100.

      Reply
  3. Liron

    Hi Venu, great article!
    I would like to know please if VMFS need to be upgraded as well in order to achieve this performance improvment?

    Reply
    1. Venu

      Hi Liron,
      The performance optimizations made are all in the vCenter Resource Management component, so it is not required to upgrade VMFS to see these latency improvements in SDRS recommendation times.

      Reply
      1. Liron

        Thanks for your response Veno.
        So just to be sure even with VMFS 5 and vCenter 6.7U1 I’ll see the improvment?

        Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

*