Home > Blogs > VMware VROOM! Blog > Tag Archives: viewplaner

Tag Archives: viewplaner

VDI Benchmarking Using View Planner on VMware Virtual SAN – Part 3

In part 1 and part 2 of the VDI/VSAN benchmarking blog series, we presented the VDI benchmark results on VSAN for 3-node, 5-node, 7-node, and 8-node cluster configurations. In this blog, we compare the VDI benchmarking performance of VSAN with an all flash storage array. The intent of this experiment is not to compare the maximum IOPS that you can achieve on these storage solutions; instead, we show how VSAN scales as we add more heavy VDI users. We found that VSAN can support a similar number of users as that of an all flash array even though VSAN is using host resources.

The characteristic of VDI workload is that they are CPU bound, but sensitive to I/O which makes View Planner a natural fit for this comparative study. We use VMware View Planner 3.0 for both VSAN and all flash SAN and consolidate as many heavy users as much we can on a particular cluster configuration while meeting the quality of service (QoS) criteria. Then, we find the difference in the number of users we can support before we run out of CPU, because I/O is not a bottleneck here. Since VSAN runs in the kernel and uses CPU on the host for its operation, we find that the CPU usage is quite minimal, and we see no more than a 5% consolidation difference for a heavy user run on VSAN compared to the all flash array.

As discussed in the previous blog, we used the same experimental setup where each VSAN host has two disk groups and each disk group has one PCI-e solid-state drive (SSD) of 200GB and six 300GB 15k RPM SAS disks. We built a 7-node and a 8-node cluster and ran View Planner to get the VDImark™ score for both VSAN and the all flash array. VDImark signifies the number of heavy users you can successfully run and meet the QoS criteria for a system under test. The VDImark for both VSAN and all flash array is shown in the following figure.

View Planner QoS (VDImark)

 

 From the above chart, we see that VSAN can consolidate 677 heavy users (VDImark) for 7-node and 767 heavy users for 8-node cluster. When compared to the all flash array, we don’t see more than 5% difference in the user consolidation. To further illustrate the Group-A and Group-B response times, we show the average response time of individual operations for these runs for both Group-A and Group-B, as follows.

Group-A Response Times

As seen in the figure above for both VSAN and the all flash array, the average response times of the most interactive operations are less than one second, which is needed to provide a good end-user experience.  Similar to the user consolidation, the response time of Group-A operations in VSAN is similar to what we saw with the all flash array.

Group-B Response Times

Group-B operations are sensitive to both CPU and IO and 95% should be less than six seconds to meet the QoS criteria. From the above figure, we see that the average response time for most of the operations is within the threshold and we see similar response time in VSAN when compared to the all flash array.

To see other parts on the VDI/VSAN benchmarking blog series, check the links below:
VDI Benchmarking Using View Planner on VMware Virtual SAN – Part 1
VDI Benchmarking Using View Planner on VMware Virtual SAN – Part 2
VDI Benchmarking Using View Planner on VMware Virtual SAN – Part 3