How-to KBTV Videos

vCenter Heartbeat Installation and Validation

We have a new video for you today which should be special interest for anyone looking to try out, evaluate or install vCenter Server Heartbeat.

In this video we discuss and demonstrate installing vCenter Server Heartbeat, and also validating the installation.

This video is a first installment of a series answering the most common questions asked by the VMware user community when deploying vCenter Server Heartbeat. Whether deploying in High Availability or Disaster Recovery deployment modes, this video will offer key points, tips and considerations for a successful deployment.

It would be worth reading up on the installation procedures in general for both the vSphere  and Heartbeat products if you have not done so previously. Below are the links to the relevant documentation sites.

  • To familiarize yourself with the Heartbeat installation requirements, see the Heartbeat documentation page here.
  • For vSphere 5.1 documentation, see the vSphere 5.1 documentation page here.

Note: For best viewing results ensure that the 720p quality setting is selected and view in full screen mode.

Enjoy the video!


0 comments have been added so far

  1. I do trust all of the concepts you have introduced to your post.
    They are very convincing and can certainly work. Still, the posts are too short
    for newbies. Could you please extend them a bit from next time?
    Thank you for the post.

Leave a Reply

Your email address will not be published.